Suspension

04001 Suspension Strut and Axle Holder (Removal and Replacement)

Correction Code : 04001 Working Hours : 1H

Pencil Pencil

NOTE:

Unless otherwise explicitly stated in the procedure, the above correction code and Working Hours reflect all of the work required to perform this procedure, including the linked procedures.
Do not stack correction codes unless explicitly told to do so.

Remove

Remove Front Wheel Assembly . See link below

10001 Front Wheel Assembly (Removal and Replacement)

Loosen upper triple clamp fasteners and triple clamp fasteners . ( Torque : 24 N-m )

Carefully move fork assemblies downward and out of triple clamps.

Install

Installation procedure is the reverse of removal.

Pencil Pencil

NOTE:

Leave 195 mm between the top edges of the lower triple clamp and inner tube oil seal, as shown