Brakes
02004 Brake oil ( Replacement)
Correction Code : 02004 Working Hours : 1H
NOTE:
Unless otherwise explicitly stated in the procedure, the above correction code and Working Hours reflect all of the work required to perform this procedure, including the linked procedures.
Do not stack correction codes unless explicitly told to do so.
Front and Rear
Step 1
Remove Rear Wheel Assy . See link below
Step 2
Remove Hand Brake Cylinder Cap ( The left side is the rear brake, and the right side is the front brake )
Step 3
Open front or rear exhaust screw ( other the side, do it again )
Step 4
Use Vacuum Brake Fluid Exchanger drain the brake oil
Tip : When draining the oil, ensure the oil level does not drop too low. If it does, add brake fluid to prevent air from entering
Step 5
After replacing the brake fluid , please fill the brake fluid to the maximum level (no bubbles visible in the window )
Foot brake
Step 1
Remove left Leg Shield . See link below
Step 2
Open the foot brake exhaust screw
Step 3
Operate the brake pedal to expel the brake oil。
Tip : When draining the oil, ensure the oil level does not drop too low. If it does, add brake fluid to prevent air from entering
Step 4
After replacing the brake fluid , please fill the brake fluid to the maximum level
Install
Installation procedure is the reverse of removal.