Drive Unit

01003 Drive Shaft Assy (Removal and Replacement)

Correction Code : 01003 Working Hours : 1.2H

Pencil Pencil

NOTE:

Unless otherwise explicitly stated in the procedure, the above correction code and Working Hours reflect all of the work required to perform this procedure, including the linked procedures.

Do not stack correction codes unless explicitly told to do so.

Remove

Remove the Spring and Danper . See link below

04003 Spring and Damper (Removal and Replacement)

Remove the Rear brake Caliper . See link below

02007 Rear Brake Caliper (Removal and Replacement)

Remove the Watt’s Bracket . See link below

04009 Watt’s Bracket (Removal and Replacement)

Remove remove the screws securing the Drive Shaft Assy and the Swing Arm ( Troque : 50 N-m )

Remove the screws securing the Drive Shaft Assy and the E-Access ( Troque : 83 N-m )

Pull the drive shaft outward

Install

Installation procedure is the reverse of removal.